|
|||||||
|
|||||||
|
|
|
|||||||
|
|||||||
|
|
| NCV4279B资料 | |
|
NCV4279B PDF Download |
|
File Size : 116 KB
Manufacturer:ON Description:Like almost all IC power regulators, the LX8385/85A/85B regulators are equipped with Safe Operating Area (SOA) protection. The SOA circuit limits the regulator's maximum output current to progres- sively lower values as the input-to-output voltage difference increases. By limiting the maximum output current, the SOA circuit keeps the amount of power that is dissipated in the regulator itself within safe limits for all values of input-to-output voltage within the operating range of the regulator. The LX8385/85A/85B SOA protection system is designed to be able to supply some output current for all values of input-to-output voltage, up to the device breakdown voltage. Under some conditions, a correctly operating SOA circuit may prevent a power supply system from returning to regulated operation after removal of an intermittent short circuit at the output of the regulator. This is a normal mode of operation which can be seen in most similar products, including older devices such as 7800 series regulators. It is most likely to occur when the power system input voltage is relatively high and the load impedance is relatively low. When the power system is started cold, both the input and output voltages are very close to zero. The output voltage closely follows the rising input voltage, and the input-to-output voltage difference is small. The SOA circuit therefore permits the regulator to supply large amounts of current as needed to develop the designed voltage level at the regulator output. Now consider the case where the regulator is supplying regulated voltage to a resistive load under steady state conditions. A moderate input-to-output voltage appears across the regulator but the voltage difference is small enough that the SOA circuitry allows sufficient current to flow through the regulator to develop the designed output voltage across the load resistance. If the output resistor is short-circuited to ground, the input-to-output voltage difference across the regulator suddenly becomes larger by the amount of voltage that had appeared across the load resistor. The SOA circuit reads the increased input-to- output voltage, and cuts back the amount of current that it will permit the regulator to supply to its output terminal. When the short circuit across the output resistor is removed, all the regulator output current will again flow through the output resistor. The maximum current that the regulator can supply to the resistor will be limited by the SOA circuit, based on the large input-to-output voltage across the regulator at the time the short circuit is removed from the output. |
|
| 相关型号 | |
| ◆ Z9036112PSC | |
| ◆ Z86C6116PSC | |
| ◆ Z84C3006PEC | |
| ◆ Z0861505PSC | |
| ◆ XTR110KP | |
| ◆ XTR106UA | |
| ◆ XTR105UA | |
| ◆ XTR101AP | |
| ◆ XN4601 | |
| ◆ XN4501 | |
| 1PCS | 100PCS | 1K | 10K | ||
| 价 格 | |||||
|
型 号：NCV4279B 厂 家：ON 封 装：SOP20 批 号：04+ 数 量：599 说 明： |
|||||
|
运 费：广东省内10元(平邮),广东省外20元(快递) 所在地：深圳市 新旧程度： |
|||||
| 联系人：黄林锋 |
| 电 话：0755-82579969,83255343 |
| 手 机：13714599954, |
| QQ：172517499,137550090 |
| MSN：zfdz168@hotmail.com |
| 传 真：0755-82738881 |
| EMail：zfdz168@163.com |
| 公司地址： 深圳市福田区华强北路华强广场B座28楼L室 |
